Prestige APS-920, Installation Manual

128-7853

6 of 16

6

false triggering of the factory alarm when the remote start unit engages or when the transmitter
is used to unlock the doors.

NOTE:

  This output can be selected to operate like the door lock output as set in alarm feature

setting #1 by selecting feature #13 of Bank 3 to as door unlock pulse.

Black w/ Light Green Trace Wire: 

Pulsed Ground Output After Start

The Black w/ Light Green Trace wire will provide a 1 second 250 mA pulsed ground output after
the vehicle is started under control of the remote start unit.  Typically this wire will be used to re-
lock the vehicle doors if the doors unlock automatically when the factory antitheft system is
disarmed.

Black w/ Red Trace Wire: 

Pulsed Ground Output After Shutdown

The Black w/ Red Trace wire will provide a 1 second 250 mA pulsed ground output after the
remote start unit shuts down.  This output will occur regardless of whether the circuit times out
or is manually terminated.   Typically this output will be used to re-lock the vehicle doors if the
doors unlock automatically when the ignition circuit transitions to off.

Black w/ Yellow Trace Wire: 

Ground Output During Start (Crank)

The Black w/ Yellow Trace wire will provide a 250 mA ground output  while the starter output of
the remote start unit is active.  This output can be used to activate the Crank Low/Bulb Test wire
found in some GM vehicles.  This wire is also referred to as the ECM wake up wire in some
Chrysler vehicles.

NOTE:

  The outputs above are low current outputs and must be used with a relay if the circuit's

requirement is more than 250 mA.

20 Pin Accessory Input/Output Harness, Connector “B”
White w/ Red Trace Wire:

 Parking Light Flasher Feed

This wire is the common contact of the on board parking light flasher relay.  If the vehicle you are
working on has +12 volt switched parking lights, connect this wire to a fused + 12 volt source.
(Max. 15 Amps)

NOTE:

 If the vehicle's parking lights are ground switched, connect this wire to chassis ground.

White Wire:

 Parking Light Flasher Output

This wire is the normally open contact of the on board parking light flasher relay.  Connect this
wire to the vehicle parking light feed wire.