Prestige APS-922E, Owner'S Manual

128-9363

21 of 24

Page 21

PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)
Transmitter Model Name, 5BCR14P & 08SP, are Found On Back Of Their Re-

spective Transmitter Case.  To Program Additional Transmitters:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps).

3)  Press the Lock Button of each transmitter you want programmed until you hear a chirp 

from the horn or siren.

4) Turn the ignition switch off.

The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons

which are 

typical for most systems. 

NOTE:  

Not all systems have channels above 3, check with your installation center for options 

your system may or may not have.

Battery Replacement:

The two way, LCD, transmitter has a slide off panel, just lift slightly and slide to cover off to 

access the AAA battery.  Replace with a fresh battery being attentive to the + & - orientation 

and dispose of the used battery properly.

The 5 button one way transmitter will require the removal of two 00 Phillips head screws 

from the rear of the case.  Once removed, pry the case halves apart with a plastic tool of the 

edge of a coin.  Remove the CR2032 Lithium battery and replace with a fresh battery being 

certain to arrange the + side facing away from the circuit board.  Reassemble the case in 

reverse of disassembly.

Erasing Transmitters When Necessary:

For Transmitters in your possession

1) Turn the ignition on.

2) Press and release the valet Push Button 3 times.

3)  Press the unlock button of any transmitter you want to erase, the unit will chirp 2 times, 

immediately release and press again the unlock button.  The transmitter will be erased and 

the unit will exit the transmitter program mode.

For Lost or Stolen Transmitters Not in your possession

1) Turn the ignition on.

2) Press and release the valet Push Button 3 times,

3)  Press and release the lock button of each transmitter you have with the intent to fill 4 

transmitter slots.  In other words, if you have 1 transmitter press lock 4 times.  If you have 

2 transmitters press lock of each transmitter 2 times each, etc. Ultimately you want the 

LED , when the ignition is turned on, to flash the number of transmitters you actually have.

To purchase replacement transmitters 

or to get additional product information go to: 

www.prestigecarsecurity.com

PATENTED:  www.voxxintl.com/company/patents