Prestige APS-922E, Installation Manual

128-9364

 12 of 28

12

30

87a

85

86

87

Black

Black/White

Existing Low Current 

Start Solenoid Wire

From Ignition Switch

Start Terminal

To Starter Motor

X

Cut

To Orange Wire 

Of Alarm/Remote Start

To + 12 Volt Ignition / Start 

Typical Vehicle Parking Lights

From Vehicle 

Park Light Switch

White From 

Remote Start Module

To + 12 Volts

(If Gnd. Switch See Note)

White/Red Wire From 

Remote Start Module

15A

4 Pin Additional Harness:

 Parking Light Flasher I/O Siren & Ground    

Part # 1284301

 1 Black: 

Chassis Ground

Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis.  

Be certain to remove any paint or grease and secure this wire with a self tapping screw and ring terminal.

 2 White w/ Red trace Wire: 

Parking Light Relay Input Wire

This wire is the common contact of the on board parking light flasher relay.  If the vehicle you are working 

on has +12 volt switched parking lights, connect this wire to a fused + 12 volt source. (Max. 15 Amps)

NOTE:

 If the vehicle's parking lights are ground switched, connect this wire to chassis ground.

 3 White w/ Black trace Wire:

(+) 

Siren Output 

This is the positive siren feed wire.  Route this wire through a grommet in the firewall to the siren location.  

Connect the White w/ Black Trace wire to the Red wire of the Siren.  Secure the Black wire of the Siren 

to a known chassis ground or solid clean metal surface.

 4 White Wire: 

Parking Light Relay Output  

This wire is the normally open contact of the on board parking light flash relay.  Connect this wire to the 

vehicle's parking light feed wire. This is the wire that gets switched on, either (+) or (-), when the vehicle's 

parking light switch is activated.