128-9364
15 of 28
15
Factory Lock Relay
Factory Unlock Relay
87a
87
30
85
86
87a
87
30
86
85
Lock
Unlock
To Red Lock Wire
Of Control Module
To Green Unlock Wire
Of Control Module
When Using DLVI
X
Cut and Splice
Per the Install
Guide Instruction
Blue
Green
To Red Lock Wire
Of Control Module
To Red/Black 2nd
Unlock Wire Of Control Module
When Using Relays
Factory Lock Relay
Factory Unlock Relay
87a
87
30
85
86
87a
87
30
85
86
To Fused + 12 Volts
To Fused + 12 Volts
(+)
From Vehicle
Chassis Ground
Drivers Door Motor
Passenger Door Motors
X
Cut Drivers Door
Unlock Motor Wire
To Green Unlock Wire
Of Control Module
If Factory Sw 12 Volts
Connect to Fused + 12 Volt Source.
If Factory switches Ground,
Connect To Ground.
87a
87
30
86
85
Fused + 12 Volt Source
Positive Switch Driver Priority
NOTE:
Resistive Circuits, Multiplex Circuits As Well As 4 Wire Polarity Reversal and 5 Wire
Alternating 12 Volt Door Lock Control Circuits
These applications require the use of additional components which may include relays, fixed resistor, a
door lock interface, or a data module. You can search the vehicle @ www.avxtech1.com, Flash-It.com for
vehicle specific information, or contact our tech service line or web site for additional information.
Additional Harnesses And Connectors For The System
6 Wire Antenna/Receiver Program Push Button Switch/LED Connector:
Part # 1124325
Plug the previously routed antenna connector from the antenna receiver assemble into the mating con-
nector of the control module. This connector supplies 12 volts, ground and RF data input and output, LED
cathode, and Valet Enable to and from the antenna receiver and the remote start module. Be certain this
connector is firmly seated making good contact to the control unit.
Summary of Contents for APS-922E
Page 27: ...128 9364 27 of 28 27 NOTES ...