128-9364
23 of 28
23
The transmitters are pre-programmed from the factory, If you find you need to program new or additional
transmitters follow the instructions below.
PROGRAMMING BANK 1
(TRANSMITTERS):
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps Once).
3) Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn
or siren.
4) Turn the ignition switch off. 1 Short followed by 1 Long Chirp indicates exit of programming mode.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons of the system. For addi-
tional channel programming see the owners guide found within the literature bag packaged with this kit.
PROGRAMMING BANK 2
(ALARM FEATURES):
You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1, you will
hear 2 chirps, or You can also go right to bank 2 by:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps Once).
3) Turn the ignition key off then on you will hear 2 chirps.
4) Press the push button switch once to advance to feature 1, twice to advance to feature 2, etc,,,then
use the lock button of the transmitter to select the feature setting.
Example to set passive arming:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off, then on, 1Siren chirps 2 times.
4) Press the push button switch six times to advance to features 6, Pass/Act Arm, then use the lock button
of the transmitter to select two chirps "Passive Arm".
5) T o exit the programming mode, turn the ignition key off ore than 6 seconds. Siren sounds a short chirp
followed by a long Chirp.
Summary of Contents for APS-922E
Page 27: ...128 9364 27 of 28 27 NOTES ...
