Prestige APS-922E, Installation Manual

128-9364

 6 of 28

6

IMPORTANT!

DO NOT PLUG THE MAIN POWER HARNESS OR THE MULTI PIN INPUT / OUTPUT HARNESS INTO 

THE CONTROL MODULE UNTIL ALL CONNECTIONS TO THE VEHICLE HAVE BEEN MADE.  AFTER 

SELECTING YOUR TARGET WIRES AS DEFINED BELOW, DISCONNECT THE NEGATIVE BATTERY 

CABLE FROM THE VEHICLE BATTERY PRIOR TO MAKING ANY CONNECTIONS.

NOTE:

Do not remove the fuse holders from this wire harness.  Fuses must be used and locat-

ed as close as possible to the power source for adequate protection of the vehicle.

 WIRING THE 6 PIN MAIN POWER HARNESS:  

PART # 1124317

NOTE:

Do not remove the fuse holders from this wire harness.  Fuses must be 

used and located as close as possible to the power source for adequate protec-

tion of the vehicle.

 1 BLUE Wire: 

 Ignition 1 Output

Connect this wire to the ignition 1 wire from the ignition switch.  This wire will show +12 volts when the 

ignition key is turned to the "ON" or "RUN" and the "START" or CRANK" positions, and will have 0 volts 

when the key is turned to the "OFF" and "ACCESSORY" positions. 

For Diesel Applications, this wire must be connected to the ignition circuit that powers the glow plugs if 

the vehicle requires glow plug pre-heating. (See selectable feature Bank 3 #12)

 2 RED/WHITE WIRE:

  + 12 volt Battery 1 Source Fused 30A

Locate the vehicle battery wire(s) at the ignition switch.  Verification: These wires will register voltage in all positions 

of the ignition switch.  Connect the Red w/White wire to the vehicle's battery wire.  This wire provides power for the 

control circuit as well as the ignition 1 and ignition 2 relays.

 3 GREEN Wire:  

Ignition 2 Output

Connect this wire to the ignition 2 wire from the ignition switch.  This wire will show + 12 volts when the 

ignition key is turned to the "ON" or "RUN" position and is some cases the "START" or CRANK" position.  

This wire will show  0 volts when the key is turned to the "OFF" and "ACCESSORY" positions.

NOTE: See programming information (Bank 3 Selection #7) concerning this wire to allow output during 

the "START" mode. 

 4 PURPLE Wire:

 Accessory Output

Connect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the

ignition switch is turned to the "ACCESSORY" or "ON" and "RUN" positions, and will show 0 volts when

the key is turned to the "OFF" and "START" or "CRANK" positions.

  5 RED WIRE: 

 + 12 Volt Battery 2 Source Fused 30A

Locate the vehicle battery wire(s) at the ignition switch.  Verification: These wires will register voltage in all positions 

of the ignition switch.  Connect the Red  wire to the vehicle's battery wire.  This wire provides power for the start 

relay and the accessory relay.

  6 YELLOW Wire: 

 Starter Output

Careful consideration for the connection of this wire must be made to prevent the vehicle from 

starting while in gear.  Understanding the difference between a mechanical and an electrical  

Neutral Start Switch will allow you to properly identify the circuit and select the correct installation 

method.   In addition you will realize  why  the connection of  the safety wire is required for all 

mechanical switch configurations.  

WARNING! 

Failure to make this connection properly can result in personal injury and property damage.

In all installations it is the responsibility of the installing technician to test the remote start unit and  ensure 

that the vehicle cannot start via RF control in any gear selection other than park or neutral.