Prestige APS-997E, Owner'S Manual

128-9309

9 of 24

Page 9

You will notice the LED flashing five times, pause, and then flash two times, pause. 

This pattern will be repeated three times indicating the new code (52) has been 

accepted and stored in memory.

NOTE:

   If after step 7, the LED flashes a code other than what was just entered, 

this indicates that the code has not been changed. You will have to repeat 

steps 1 through 7 above being certain to note the following: 

Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 

(Zero), or no digit entered in any place, units or tenths.

NOTE:  

If 15 seconds of inactivity expire, or if the ignition switch is turned off for more 

then 5 seconds during any of the above steps, the unit will revert back to the 

last successfully stored code.

 MANUALLY OVERRIDING YOUR SYSTEM:
 USING THE CUSTOM CODE OVERRIDE

Assuming the override code programmed has not been changed, and the default override 

code of 11 is in the system's memory.

1)  Enter the vehicle and turn the ignition switch to the on position.

NOTE:

 The siren will sound.

2)   Within 5 seconds, press and release the Receivers push button switch 1 time.

3)  Within 5 seconds, turn the ignition switch off then on.

4)  Within 5 seconds, press and release the Receivers push button switch 1 time.

5)   Turn the ignition switch off then on and start the vehicle. 

NOTE:

   If you have changed the programmed override code then substitute your new 

code tenths for step 2 above, and units for step 5 above. 

 ELIMINATING THE NORMAL  ARM/DISARM CHIRPS

You can selectively eliminate the normal arm and disarm chirps by holding the 

transmitter button slightly longer when arming or disarming. This will prevent the 

siren chirps for one arm or disarm cycle.  If you find this inconvenient and wish to 

eliminate these chirps permanently,

1. Turn the ignition switch 'on" then 'off".

2. Within 10 seconds of turning off the ignition, press and release the Receivers 

push button switch 3 times.

3.  If the chirps were on before you started, the siren will emit 2 short chirps indicating 

that the chirps are now off.  If the chirps were off before you started, the siren 

will emit one short chirp indicating that the chirps are now on.

NOTE:

   If the vehicle battery is disconnected then reconnected, the unit will return 

to the default setting of chirps on.  Repeat the above procedure to eliminate 

the arm/disarm chirps.

NOTE:

    Your system must be programmed by the installation center to enable this 

feature. 

NOTE:

   Whenever the chirps are bypassed, the 4-chirp intrusion indicator and 

3  chirp  defective  zone  indicator  will  always  operate.  Since  these  are 

important warnings to you that something has happened, they cannot be 

eliminated.

NOTE:

   Your system must be programmed by the installation center to enable this 

feature.