128-9481
4 of 4
© 2017 Voxx Electronics Corporation., 180 Marcus Blvd., Hauppauge, NY 11788
128-9481
PATENTED: www.voxxintl.com/company/patents
To purchase replacement transmitters or to get additional product
information go to: www.prestigecarsecurity.com
stance will the system allow a transmitter button to be programmed into 2 receiver
channels at the same time.
Transmitter Battery Replacement:
1) Separate the transmitter halves by inserting a coin in the slot found on the lower
right side of the transmitter case. Be careful not to drop the transmitter contents.
2) Slide the CR 2032 battery from the battery holder paying attention to the battery
orientation's (+) side facing away from the circuit board.
3) Replace the battery with a new one and reassemble the case in reverse of
disassembly.
FUNCTION SETTING CHART
To be completed by installer
Run Time
_______Min
Door Lock Timer
_______Sec
Parking Lights
Pulse
Steady
WARNING!
A running vehicle produces dangerous carbon monoxide gas
which can be fatal if prolonged exposure occurs. Be certain the vehicle is
outdoors before activating the remote start function.
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Warning!
Changes or modifications made to this equipment not expressly approved by the part responsible for compliance could
void the use’s authority to operate the equipment
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to operate the equipment.
4
