9
Roller rest
The roller rest should be removed and cleaned in hot soapy water at least once a week to
prevent grease restricting the rotation of the wheels.
Door
The door and door seals should be kept clean at all times. Use only warm soapy water rinse
then dry thoroughly.
DO NOT USE ABRASIVE MATERIALS, SUCH AS CLEANING POWDERS OR STEEL AND
PLASTIC PADS.
Metal parts will be easier to maintain if wiped frequently with a damp cloth.
Exterior
Clean with mild soap and warm water, rinse and dry with a soft cloth. Do not use abrasive
materials. Do not spill water in the vents. If the power lead becomes soiled wipe it with a
damp cloth.
Only warm soapy water must be used to clean stainless steel surfaces
OPERATING PROCEDUCE
Special points to note
1.
Each time a pad is touched, a BEEP will sound to acknowledge the touch.
2.
The interior light is only on when the microwave oven is operating.
3.
The door can be opened at any time during operation. The oven will automatically
shut off.
4.
The oven automatically cooks on full power unless set to a lower power level.
5.
The display will show "0:00" when the oven is plugged in.
6.
When cooking is complete the display will revert to the time of day.
7.
When the stop/clear pad is touched during the oven operation, the oven stops
cooking and all information retained. To erase all information (except the time of day), touch
the stop/clear pad once more. If the oven door is opened during the oven operation, all
information is retained.
8.
If the start pad is touch and the oven does not operate, check the area between the
door and door seal for obstructions and make sure the door is closed securely. The oven will
not start cooking until the door is completely closed or the program has been reset.
Setting the time of day
When the oven is first plugged in the display will show "0:00" to set the clock
1.
Press the Clock/Pre-set pad and the hour figure "0" will flash.
2.
Turn the rotary switch to set the correct hour.
3.
Press the Clock/Pre-set pad again and the minute "00" figures will flash.
4.
Turn the rotary switch to set the correct minute.
5.
Press the Clock/Pre-set once again and the time of day is set.
Note:
This is a 24 hour clock. When the oven is plugged in, "0:00" will appear in the display.
To reset the time of day repeat the steps 1 to 5 above.