128-7405B
1 of 28
Model APS-998
Installation Manual
The select
able features can be set manually as explained below
, or with the RF feature programmer
.
T
o
set features using the RF programmer
, follow the instructions p
ackaged with the programmer
.
Factory default settings are indicated by bold text.
Note :
The method of manual override can either be selected to operate from the valet switch or operate as custom code.
Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.
Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no s
election will be available.
RF Programmable Feature Bank 1 Is For T
ransmitter Programming See T
ransmitter Programming Guide.
RF Programmable Features Bank 2 Is Alarm Selectable Features:
Feature Selection
1 Chirp
2 Chirps
3 Chirps
4 Chirps
5 Chirps
6 Chirps
1st DoorL/UL
1 Sec.
3.5
Sec.
1 Sec L, Dbl. U/L
Dbl L, 1 Sec UL
Dbl
L,
Dbl
UL
1
S
l/350mS
ul
2nd
Accy
Lock
Auto Lock On
Auto Lock Off
3rd
Accy
. UL
Auto
UL
Dr
.
Auto
UL
A
ll
Auto UL Off
4th Headlights
On
Arm
On
Disarm
On Both
Off
5th Passive
Locks
Passive
Active
6th Pass/Act
Arm
Passive Arm
Active Arm
7th Siren/Horn
Siren/Horn
Siren Only
Horn
Only
8th Horn Chirp
10mS
16mS
30mS
40mS
50mS
9th O/R Method
Custom
Code
V
alet
10th 2 S
tep U/L
O
n
Off
1
1th Chp Del
Tx
O
n
Off
12th V
olt
s/HdW
ire
Not A
vailable
13th Trigger Circuits
Not
A
vailable
14th L/UL Poll
Not A
vailable
When using the RF programmer
, enter the program mode as follows:
Turn the ignition on
Press and release valet switch 3 times
turn ignition off then on
Press and hold valet switch for 5 seconds
Siren chirps 2 times indicating access to RF feature program mode.
Action
System Response
Rev to "a" to add Fuses To Harness and PBLED 7/06
Rev to "b" to 136-4002 Updated F/W to add DBI Tach, Module Rev 6. 6-30-08
