128-8115
1 of 19
Page 1
The select
able features can be set manually as explained below
, or with the RF feature programmer
.
T
o
set features using the RF programmer
, follow the instructions p
ackaged with the programmer
.
Factory default settings are indicated by bold text.
Note :
The method of manual override can either be selected to operate from the valet switch or operate as custom code.
Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.
Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no s
election will be available.
RF Programmable Feature Bank 1 Is For T
ransmitter Programming See T
ransmitter Programming Guide.
RF Programmable Features Bank 2 Is Alarm Selectable Features:
Feature Selection
1 Chirp
2 Chirps
3 Chirps
4 Chirps
5 Chirps
6 Chirps
1st DoorL/UL
1 Sec.
3.5
Sec.
1 Sec L, Dbl. U/L
Dbl L, 1 Sec UL
Dbl
L,
Dbl
UL
1
S
l/350mS
ul
2nd
Accy Lock
Not Available
3rd
Accy
. UL
Not Available
4th Headlights
Not Available
5th Passive Locks
Not Available
6th Pass/Act
Arm
Not Available
7th Siren/Horn
Not Available
8th Horn Chirp
Not Available
9th O/R Method
Not Available
10th 2 S
tep U/L
Not Available
1
1th Chp Del
Tx
Not Available
12th V
olt
age/Hd W
ire
Not Available
13th Trigger Circuits
Not Available
14th Lock/Unlock Poll
Not Available
15th
Aux Ch 5 Sel
Not Available
16th
Aux Ch 6 Sel
Not Available
17th
Aux Ch 7 Sel
Not Available
18th Trigger Delay
Not Available
When using the RF programmer
, enter the program mode as follows:
Turn the ignition on
Press and release valet switch 3 times
turn ignition off then on
Press and hold valet switch for 5 seconds
Siren and or lights chirp/flash 2 times indicating access to RF feature program mode.
Model APS-921
Installation Manual
