Prestigio Nobile 1522E
33
ENG
5. If you need to remove an old DIMM from the socket, press out on the latches located on both edges of the socket at
the same time. The DIMM should pop up to an angle of 30 degree (see diagram below). Pull the DIMM module out of
the memory socket. Store away the DIMM for the future use.
6. Install the new DIMM module into the memory socket. The DIMM will only fit in one orientation. Insert the
DIMM at an angle of approximately 30 degrees into the empty memory socket. Then press it firmly so that the
contact edge is driven into the receiving socket.
7. Pivot the DIMM until the latches on both sides of the socket snap into place.
Note
: Notice the notch on the DIMM. The notches should fit nicely with the socket.
8. Put the System Device Cover back and tighten 9 Screw A’s.
