38
PRESTIGIO NOBILE 1522W
ENG
I cannot connect to another WLAN device.
* Make sure that the WLAN feature is turned on.
* Make sure that the SSID setting is the same for every WLAN device in the network.
* Your computer is not recognizing changes. Restart the computer.
* Make sure that the IP address or subnet mask setting is correct.
I cannot communicate with the computer in the network when Infrastructure mode is configured.
* Make sure that the Access Point your computer is associated with is powered on and all the LEDs are working properly.
* If the operating radio channel is in poor quality, change the Access Point and all the wireless station(s) within the BSSID
to another radio channel.
* Your computer may be in an out-of-range situation. Move your computer closer to the Access Point it is associated
with.
* Make sure that your computer is configured with the same security option (encryption) to the Access Point.
* Use the Web Manager/Telnet of the Access Point to check whether it is connected to the network.
* Reconfigure and reset the Access Point.
I cannot access the network.
* Make sure that the necessary driver(s) is correctly installed.
* Make sure that the network configuration is appropriate.
* Make sure that the user name or password is correct.
* You have moved out of range of the network.
* Turn off power management.
Modem Problems
The modem does not work.
* Make sure that the modem driver is correctly installed.
* Make sure that the telephone line is properly connected.
* Make sure that the COM port in the communication software is correctly set.
* Turn off power management.
Power Management Problems
The computer does not enter Standby or Hibernation mode automatically.
* If you have a connection to another computer, the computer does not enter Standby or Hibernation mode if the
connection is actively in use.
* Make sure that the Standby or Hibernation time-out is enabled.
The computer does not enter Standby or Hibernation mode immediately.
* If the computer is performing an operation, it normally waits for the operation to finish.
The computer does not resume from Standby or Hibernation mode.
* The computer automatically enters Standby or Hibernation mode when the battery pack is empty. Do any one of the
following:
Connect the AC adapter to the computer.
Replace the empty battery pack with a fully charged one.
The computer does not enter Hibernation mode with the Fn+F12 hot keys.
* Make sure that the Hibernation function is specified for the sleep button.
* You might be using an ExpressCard that prevents the computer from entering Hibernation mode. To enter the mode,
stop the communication program and then remove the card or stop the card.
