31
PRESTIGIO NOBILE 1560
ENG
N
OTHING
APPEARS
ON
THE
SCREEN
.
The computer’s power management system automatically blanks the screen to save power. Press any key to turn the display
back on.
If pressing a key does not turn the display back on, two things might be the cause:
• The brightness level might be too low. Press Fn-< and Fn-> to adjust the brightness level.
• The display device might be set to an external monitor. Press the display toggle hot key Fn-F3 to toggle the display back
to the computer.
I
MAGE
IS
NOT
FULL
-
SCREEN
.
Make sure the resolution is set to a resolution your system supports. Right-click on your Windows desktop and select
Properties to bring up the Display Properties dialog box. Then click on the Settings tab to make sure the resolution is set to
the appropriate resolution. Resolutions lower than the specified resolution are not full-screen on the computer or on an
external monitor.
N
O
AUDIO
FROM
THE
COMPUTER
.
Check the following:
• The volume may be muted. In Windows, look at the volume control icon on the taskbar. If it is crossed-out, click on the icon
and deselect the Mute option.
• The speakers may be turned off. Press Fn-F5 to turn the speakers on (this hotkey also turns the speakers off).
• The volume level may be too low. Adjust the volume control knob near the left rear side of your computer. In Windows,
look at the volume control icon on the taskbar. Click on the icon and adjust the level.
If headphones, earphones or external speakers are connected to the line-out port on the computer’s rear panel, the internal
speakers automatically turn off.
T
HE
KEYBOARD
DOES
NOT
RESPOND
.
Try attaching an external keyboard to the USB connector on the computer’s rear. If it works, contact your dealer or an
authorized service center as the internal keyboard cable may be loose.
T
HE
PRINTER
DOES
NOT
WORK
.
Check the following:
• Make sure that the printer is connected to a power outlet and it is turned on.
• Make sure the printer cable is connected securely to the computer’s USB port and the corresponding port on the printer.
I
WANT
TO
SET
UP
MY
LOCATION
TO
USE
THE
INTERNAL
MODEM
.
To properly use your communications software (e.g., HyperTerminal), you need to set up your location:
1. Click on Start, Control Panel; then double-click on the Phone and Modem Options icon.
2. Begin setting up your location.
Refer to the Windows manual.
W
HY
CAN
’
T
I
CHARGE
MY
BATTERY
TO
100%
CHARGED
WHEN
IT
IS
99-95%
CHARGED
?
To preserve the life of the battery, the system only lets you charge the battery when its capacity falls below 95%. However,
it is recommended that you bring an extra battery and let the battery in the system use up its power before charging it.
W
HY
WON
’
T
MY
TOUCHPAD
WORK
?
Your touchpad might be disabled, use the hotkey Fn-F6 to enable it. See “Hotkeys” for more informations.
