PRETUL 28113, Manual

3

ENGLISH

ROTO-3/8P6

Technical Data

28113

18 AWG x 2C with insulating temperature of 221 °F

Wood 1”  |  Concrete 3/8”  |  Metal 3/8” 

20 minutes work per 10 minutes idle. Maximum 1 hour 30 minutes per day.

Power Cord Grips used in this product: Type Y.

Tool Build Quality: Reinforced insulation.

Thermal insulation on motor winding: Class B.

60 Hz

Hammer drill

0 - 3 000 RPM

4.2 A

0.73 Hp

127 V

3/8”

Code

Conductors

Drilling Capacity

Insulating

Duty Cycle

Description

Voltage

Frequency

Current

Power

Speed

0 - 48 000 BPM

Impact

Chuck

Avoid the risk of electric shock or severe injury. When the power cable gets damaged 

it should only be replaced by the manufacturer or at a                                 Authorized Service Center.

The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.

Do not expose to rain, liquids and/or dampness.

Before gaining access to the terminals all power sources should be disconnected.

WARNING

WARNING

Class II

IP20

IP Grade

Power Requirements

from 0 A and up to 10 A

from 10 A and up to 13 A

from 13 A and up to 15 A

from 15 A and up to 20 A

18 AWG(*)

16 AWG

14 AWG

8 AWG

16 AWG

14 AWG

12 AWG

6 AWG

3 (one grounded)

from 5.91’ to 49.2’         |         higher than 49.2’

Ampere

Capacity

Number of

Conductors

Extension gauge

* It is safe to use only if the extensions have a built-in artifact for over current protection.

AWG = American Wire Gauge. Reference: NMX-J-195-ANCE

Tools with double insulation and reinforced insulation are 

equipped with a polarized plug (one prong is wider than the other). This plug will 

only fit in the right way into a polarized outlet. If the plug cannot be introduced into 

the outlet, reverse the plug. If it still doesn’t fit, call a qualified electrician to install 

for you a polarized outlet. Do not alter the plug in any way. Both insulation types 

eliminate the need of both a grounded third power cord with three prongs

or a grounded power connection.

When using an extension cable, verify the gauge is enough for the power that your product needs. A lower 

gauge cable will cause voltage drop in the line, resulting in power loss and overheating. The following table shows the right 

size to use depending on cable’s length and the ampere capability shown in the tool’s nameplate. When in doubt use the 

next higher gauge.

WARNING

WARNING

WARNING

When operating power tools outdoors, use a                       grounded 

extension cable labeled “For Outdoors Use”. These extensions are especially designed 

for operating outdoors and reduce the risk of electric shock.