9
Start Up
Before starting the pump some topics need
to be taken care of. Otherwise it can get damaged and the
Warranty cancelled:
• All the hoses shall be disconnected, totally untangled and
with no kinks.
• Water supply shall be connected and fully open.
• Gasoline and oil levels shall be right.
• The system shall be purged as previously indicated.
• Move the throttle lever (
G
) into the low speed position ( ).
• Turn off the switch (
C
).
• Move the fuel lever (
A
) moving the lever into the closed (
OFF
) position.
• Move the choke lever (
D
) into the “OFF” position.
• To stop the motor during an emergency, set the motor switch directly intp the “OFF” position.
Shut OFF
• Open the fuel valve (
A
).
• Move the choke lever into the off
position (
B
).
• Set the switch (
C
) in the ON position (
I
).
• Move the throttle lever (
G
) to the
high-speed position ( ).
• Slowly pull the starter lever (
D
) until filling resistance in the line. Then, pull with force to start
the motor. Carefully return the lever to its place. do not release it, otherwise it
would snap back and get damaged.
• Allow the motor to run 5 seconds, and then move the choke lever into the “ON” position (
E
).
• Keep on paying CAUTION to the water source level because during the
pumping operation the level could go so low until the suction hose end is out of the water. In
this situation turn off the pump immediately and correct the suction hose depth. Avoid making
the pump function with no water, otherwise it may get damaged.
Start Up
CAUTION
CAUTION
CAUTION
CAUTION
G
D
B
C
A
D
E
ENGLISH
Summary of Contents for 28114
Page 13: ...Notes 13 ENGLISH ...
Page 14: ...14 ENGLISH Notes ...
Page 19: ...14 ESPAÑOL Notas ...
Page 20: ...Notas 13 ESPAÑOL ...
