PREVOST LE MIRAGE XLII BUS SHELLS Maintenance Manual Download

Page: 150 / 1260

Section 6: ELECTRICAL

PA1564

maximum allowable road illumination. When
using mechanical aiming devices, follow
manufacturer’s instructions.

Headlight aim should be checked after installing
a new bulb. Aiming can be performed without
opening headlight assembly. Horizontal and
vertical aiming of each module is provided by
two adjusting screws that pivot the module in the
housing for proper alignment (fig. 27). There is
no adjustment for focus since the module is set
for proper focus during manufacturing assembly.

FIGURE 28: OPENING HEADLIGHT ASSEMBLY

06547

NOTE

Make sure headlight assembly is properly
positioned into its housing before securing
using fixing screw.

CAUTION

Use a soft cloth to clean the parking and front
turn signal lamp.

9.1.3 Headlight

Adjustment

1. Headlight aiming and inspection can be

accomplished by visual means. This is done
on a screen located at a distance of 25 feet
(7,6 m) of the headlights. It should be of
adequate size with a matte-white surface
well shaded from extraneous light and
properly adjusted to the floor area on which
the vehicle stands. Provisions should be
made for moving the screen or its vertical
centerline so that it can be aligned with the
vehicle axis. In addition to the vertical
centerline, the screen should be provided
with four laterally adjustable vertical tapes
and two vertically adjustable horizontal
tapes.

2. The four movable vertical tapes should be

located on the screen at the left and right
limits called for in the specification with
reference to centerlines ahead of each
headlight assembly.

3. The headlight centerlines shall be spaced

either side of the fixed centerline on the
screen by ½ the lateral distance between
the light source centers of the pertinent
headlights. The horizontal tapes should be
located on the screen at the upper and
lower limits called for in the specification
with reference to the height of beam centers
and the plane on which the vehicle rests, not
the floor on which the screen rests (Fig. 29).

4. The nominal vertical aim position on lower

beam headlights shall be adjusted based on
the headlight mounting height, from the
ground to the light source center of the
headlight, according to table1.

TABLE 1 – VERTICAL BEAM AIM GUIDELINES

Headlight

(centerline)

Mounting Height

Nominal

Vertical

Aim

Aim Inspection

Limits for Vertical

Aim

56 to 90 cm (22 to
36 inch)

0 Vertical

10 cm (4 inch) up to
10 cm ( 4 inch) down

90 to 120 cm (36 to
48 inch)

5 cm (2 inch)
down

5 cm (2 inch) up to 15
cm (6 inch) down

120 to 140 cm (48 to
54 inch)

6.4 cm (4
inch) down

4 cm (1.5 inch) up to
16.5 cm (6.5 inch)
down

5. High beam headlights are aimed so that the

center of the high-intensity zone is located
at the horizontal and straight ahead
vertically (Fig. 30).

6. Low beam headlights are aimed so that the

top edge (the cutoff) of the high-intensity
zone is at the vertical location as per Table
1 and the left edge of the high-intensity zone
is at the vertical centerline of the headlight
(Fig. 31).

PREVOST LE MIRAGE XLII BUS SHELLS, Maintenance Manual

Search results

Summary of Contents for LE MIRAGE XLII BUS SHELLS

Reviews:

Related manuals for LE MIRAGE XLII BUS SHELLS

Brands by name

Popular brands