Other
Features
113
Timer operating instructions (Spheros)
TIMER
22223
These instructions refer to the Spheros timer
illustrated above.
Remaining Operating Time
The remaining operating time refers to the
period of time the heater still continues to remain
in operation. It may be changed while the
heater is in operation.
Setting the Digital Timer
After the power has been connected, all
symbols on the digital display are flashing. The
time of the day and the day of the week must be
set.
All flashing symbols of the timer can be set by
means of the Forward (9) or Reverse (8)
buttons.
When buttons (8) and (9) are pressed for more
than 2 seconds, the quick digit advance mode is
activated.
Setting the Time and Day of the Week
1. Press button (5) for more than 2 seconds
(time display flashes).
2. Press (8) or (9) button to set the time of day.
3. Wait 5 seconds. The time of day is stored
(day of week flashes).
4. Press (8) or (9) button to set the correct day
of week.
5. Wait 5 seconds. The day of week is stored.
Viewing the Time (Ignition ON)
Continuous display of current time and day of
the week.
Viewing the Time (Ignition OFF)
Briefly press button (5) to display current time
and day for 5 seconds.
Switching Heater ON (Instant Heating) With
Ignition ON:
Press button (7). Heater is switched on
(continuous operation) and continues to operate
until button (7) is pressed again or ignition is
switched off.
NOTE
If the ignition is switched off while heater is in
operation, the remaining operating time of 15
minutes flashes on the display and the heater
will continue to operate for this period of time.
Switching Heater ON (Instant Heating) With
Ignition OFF:
Press button (7). Heater is switched on for
preset operating time (the factory-set heater
operating duration is 60 minutes)
Switching Heater OFF
Press button (7). The heater starts its after-run
cycle and switches off thereafter.
Presetting Starting Time
1. Press button (6). Memory location number
flashes.
NOTE
By repeatedly pressing button (6), starting
time 2 or 3 can be preset.
2. Press button (8) or (9) until correct startup
time is set.
3. Wait 5 seconds. Preset starting time is
stored and day of week flashes.
4. Press button (8) or (9) to select the correct
startup day of week.
5. Wait 5 seconds. The startup day of week is
stored.
The number of memory location remains on the
display. The timer is now in the programmed
mode and will switch the heater on at the preset
time.
NOTE
We recommend that memory locations 1 and
2 be used for presetting times within 24 hours
of setting the timer. Memory location 3 can be
used for a starting time within the next 7 days
of setting the timer.
Summary of Contents for X3-45 2011
