PREVOST X3-45 2011 Operator'S Manual Download

Page: 120 / 214

Other Features

114

Recalling Preset Times

Press (6) repeatedly until the desired memory
location number and preset time are displayed.

Canceling Preset Time

Press button (6) repeatedly until no more
memory location number is visible on the
display.

Setting Operating Time

1. With heater off, press button (8). Operating

time flashes.

2. Press button (8) or (9) to set the operating

time (between 1 and 120 minutes)

3. Wait 5 seconds. Operating time is stored.

The heater remains in operation for the preset
time (except for continuous operation).

Setting the Remaining Operating Time

1. With heater in operation, press button (8).

Remaining operating time flashes.

2. Set remaining time with button (8) or (9).

3. Wait 5 seconds. Remaining operating time

is stored.

TROUBLESHOOTING AND MAINTENANCE

The diagnostic code system in Webasto timers
is standard. Refer to the Maintenance Manual
and to Webasto manual for more information.

NOTE

If there are no heater faults, the heater will go
through a normal start cycle and regulate
based on thermostat setting.

NOTE

Switch on the preheating system briefly about
once a month, even during the warm season.

CAUTION

When welding on the vehicle, disconnect the
preheater module connector in order to
protect this system from voltage surges.

CAUTION

To avoid running down the batteries, do not
turn on the preheating system for more than
one hour before starting the engine.

WARNING

The preheating system uses the same fuel as
the engine. Do not operate in a building or
while refueling. Operate only in a well-
ventilated area.

WHEELCHAIR LIFT SYSTEM

Read and understand the RICON
Service/Owner Manual before attempting to use
the wheelchair lift. The instructions below are a
quick reference and serve to complement the
information provided by RICON.

WARNING

To operate the optional wheelchair lift, the
coach must be parked on a flat and level
surface, with the parking brake applied.

Activate the lift mechanism circuit by pressing
down on the wheelchair rocker switch on the
dashboard.

WHEELCHAIR LIFT AND ACCESS DOORS

Open the lift mechanism access door and
carefully lower. Pull the wheelchair access door
operating handle in the left section of the lift
mechanism compartment and swing the door
until locked open.

A light inside the vehicle illuminates the doorway
when the wheelchair access door is open.

A telltale light on the dashboard illuminates
when the lift mechanism access door or the
wheelchair access door is open. Refer to
Controls and Instruments chapter.

When either the lift mechanism access door or
the wheelchair access door is open, the parking
brake cannot be released and the transmission
gear selector will not register any gear selection.
The activation switch must be is in the ON
position for this interlock feature to be in effect.

If in motion and the access door opens, a telltale
light will illuminate and an audible alert will
sound.

To close the door, take the tension off the
locking mechanism by pushing the door more
open, then pull on the tab at the bottom of the
door to unlock from the open position, and then
slam the door shut.