Other Features
118
Lap belt
anchor pin
Tension
release lever
Unlock
pin
Retractor knob
BELT ANCHORING AND RETRACTION SYSTEMS
23266
Two of the four retaining belts have attaching
pins on the retractors to secure the occupant’s
lap belt. They must be placed at the rear of the
wheelchair.
Each tiedown retractor slots into a floor
anchorage track.
To anchor the retaining belts, lift the track cover,
push in the retractor anchor then slide it until it
locks in place. Hook one strap to each corner of
the wheelchair frame (not the wheels) and allow
the retractors to tension the belts.
To remove the restraint belts, release tension in
the locking mechanism by tightening the belt
slightly more with the retractor knob before
pushing down on the red release lever on the
retractor. Unhook the wheelchair and allow the
belts to retract. Guide the belts in, making sure
they remain untwisted as they retract.
Release the anchor by lifting the lock pin then
sliding out and up the anchor from the floor
track. Close the lid on the tracks to prevent dirt
from entering the track cavity.
WARNING
Do not let restraint or safety belts rub against
sharp edges. Do not bleach or dry clean.
Wheelchair Occupant Restraint
Secure the wheelchair occupant in the following
manner:
WHEELCHAIR RESTRAINTS AND ACCESSORIES
23262
Snap the lap belts to the pins on the retractors of
the rear restraint belts. Adjust the lap belt so it
sits snug across the hips. Snap the shoulder belt
to the pin on the lap belt. A retractor adjusts
shoulder belt length automatically.
To release the belt, unsnap the shoulder belt
then press the red button in the center of the
buckle.
WARNING
A snug fit with the lap belt positioned low on
the hips is necessary to maximize safety. The
belt should not be worn or twisted. Avoid
pinching the belt and/or hardware. Do not
wear over rigid or breakable objects such as
eyeglasses, pens or keys as these may cause
injuries.
EMERGENCY OPERATION
In the event of electrical power loss, manual
operation of the lift is possible as explained
below.
To manually deploy the platform
Allow enough space for lift operation and
passenger boarding. If a break down situation
exists and the vehicle cannot be moved so that
the lift system can be operated safely, the
operator must summon emergency assistance
to move the vehicle before operating the lift.
Fully open wheelchair access and lift doors.
Ensure that there are no obstacles in the path of
the lift.
Summary of Contents for X3-45 2011
