Other
Features
119
WHEELCHAIR LIFT MANUAL OPERATION
23375
Remove the pump handle from inside the lift
mechanism access door.
Turn one of the manual platform release shafts
using pump handle extension.
MANUAL PLATFORM RELEASE SHAFT
23334
Grasp the platform and pull firmly until the lift is
all the way out against the carriage stops.
To manually raise the platform
Remove the pump handle from inside the lift
mechanism access door.
Push the pump release valve actuating rod UP.
CAUTION
During manual rising of the lift, do not raise
the platform more than 1-1/2 inches above the
vehicle floor level. Any excessive travel will
make it difficult to enter the platform and/or
damage the lift bridge plate actuator. The
outer edge of the bridge plate must rest
squarely on the vehicle floor.
Insert handle extension into manual backup
pump handle socket and pump to raise the
platform to the vehicle floor level.
WHEELCHAIR LIFT MANUAL HYDRAULIC PUMP
23373
The lift passenger and attendant must follow the
instructions to ENTER or EXIT the vehicle, as
previously described.
To manually lower the platform
Slowly pull the pump release valve actuating rod
DOWN until th platform begins to lower.
Allow the platform to reach ground level.
Push the pump release valve actuating rod back
UP until lightly-snug.
Using the rollstop manual control knob and one
hand on the rollstop, OPEN the rollstop.
The attendant and lift passenger should follow
the instructions to ENTER or EXIT the vehicle,
as described previously.
ROLLSTOP MANUAL CONTROL KNOB
23275
To manually stow the platform
Raise or lower the platform to the deploy/stow
position; the platform frame must be parallel to
the side of the lift enclosure. If the exact position
cannot be obtained, slightly low is preferred to
slightly high.
Using the rollstop manual control knob and one
hand one the rollstop, close the rollstop until it
latches.
Summary of Contents for X3-45 2011
