Care and Maintenance
158
Go to the front of the vehicle and check the
lights:
•
First the left and right directional signals.
•
Identification
lights and clearance lights.
•
Low
beams.
•
High
beams.
Go to the left side of the vehicle:
•
Directional
signals.
•
Marker
lights.
•
Directional
signals.
•
Marker
lights.
VARIOUS LIGHTS LOCATION
Go to the rear of the vehicle:
•
Directional
signals.
•
Identification
lights and clearance lights.
•
Stoplights and taillights.
•
Back-up lights and back-up alarm
(option).
IMPORTANT NOTE
To check the back-up lights and back-up
alarm, you must flip the starter selector switch
to REAR START position. (If the engine is
running, do this quick enough so that the
engine does not stop).
Go to the right side of the vehicle (same
sequence as left side).
FIRST SERVICE ON NEW VEHICLE
NOTE
Refer to Maintenance Manual for precise
service schedule.
ENGINE OIL
Preliminary oil change is not required since the
engine has been test-run at the factory. Change
oil and filter as specified in Section 24 of the
Maintenance Manual.
COOLANT SYSTEM FILTER
The coolant system filter is designed to recover
the soldering residues trapped inside the coolant
lines during their initial assembly. Clean filter
after first 3,000 miles (5 000 km) and then every
50,000 miles (80 000 km). Refer to the
Maintenance Manual under section 05: Cooling
System.
NOTE
If soldering has been performed on cooling
system, clean filter after 3,000 miles (5 000
km).
Summary of Contents for X3-45 2011
