Controls and Instruments
57
OPERATION OF THE DRIVER MICROPHONE
1. Press D-MIC button to turn on
the driver microphone. The
AUDIO section of the LCD panel
will show “D-MIC” and a gong
sound can be heard.
2. Turn volume knob to adjust
microphone level.
3. Press D-MIC button again to turn
off the driver microphone.
OPERATION OF THE GUIDE MICROPHONE
1. Press G-MIC button to turn on
the guide microphone. The
AUDIO section of the LCD panel
will show “G-MIC” and a gong
sound can be heard.
2. Turn volume knob to adjust
microphone level.
3. Press G-MIC button again to
turn off the guide microphone.
NOTE
The driver and guide microphones can be
turned on only by turning the switch on the
microphone to on.
If both the driver and guide microphone are
activated, the driver microphone has priority
and the guide microphone is muted.
BACKGROUND VOLUME ADJUSTMENT
When a microphone is activated, the current
audio source volume will reduce to a certain
level which as been set at the factory. To adjust
this level, proceed as follows:
1-
Press and hold AUDIO button then
press AUDIO IN button. The LCD panel
will show “BACK GROUND”.
2- Turn the volume knob to adjust the
background level.
3- Press any button to save the setting. If
no button is pressed within 8 seconds,
the unit automatically saves the setting
and exits this mode.
GONG SOUND LEVEL
A gong will sound in the passenger’s area upon
activating of the microphone. This gong will also
sound when a passenger activates the service
bell. The gong sound level can be adjusted as
follows:
1- Press and hold AUDIO button then
press VIDEO IN button. The LCD panel
will show “GONG PASS”.
2- Turn the volume knob to adjust the gong
level.
3- Press any button to save the setting. If
no button is pressed within 8 seconds,
the unit automatically saves the setting
and exits this mode.
NOTE
While maintaining the service bell gong active,
the gong sound heard upon activation of the
microphones can be disabled. To do so,
1-
Press
and hold AUDIO button then
press G-MIC button.
The LCD panel
will show “GONG MIC ON” or “GONG
MIC OFF”.
2- Turn the volume knob clockwise to
activate the microphones gong sound.
Turn the volume knob
counterclockwise to deactivate the
microphones gong sound.
USING THE VSS-05 REMOTE CONTROL
1.
Press this button to turn on the
unit.
Press this button again to turn
off the unit.
2. R/CD, AU IN, DVD, TV, VI IN
Press one of these buttons to
select the relevant audio or
audio/video source.
3. DMIC
Press
DMIC
button to turn on the driver
microphone.
Press
DMIC
button again to turn off the driver
microphone.
4. GMIC
Press
GMIC
button to turn on the guide
microphone.
Press
GMIC
button again to turn off the guide
microphone.
5. CAM
Press
CAM
button to select the optional
panoramic view camera signal.
Summary of Contents for X3-45 2011
