Safety Precautions 1-3
PA1627 X3-45 Operator’s Manual
OTHER PRECAUTIONS
WARNING
This vehicle is not designed to carry
standing passengers.
WARNING
CALIFORNIA PROPOSITION 65:
Diesel engine exhaust and some of its
constituents are known to the State of
California to cause cancer, birth defects
and other reproductive harm.
Battery posts, terminals and other related
accessories contain lead and lead
compounds, chemical known to the State
of California to cause cancer and other
reproductive harm.
Batteries also contain other chemicals
known to the State of California to cause
cancer.
Wash hands after handling.
DANGER
Make sure that electrical current or air
pressure is removed before performing any
work. A part may be energized even if the
ignition switch is OFF. A part may be under
pressure even if all tanks are empty.
Before performing any work on the vehicle,
refer to wiring diagrams and/or air
schematics to thoroughly understand the
system.
NOTE
When the ignition switch is set to the OFF
position, the electrical components are not
energized except for the MCM (Master
Chassis Module), the battery equalizer, the
preheater system and some electronic
modules; which are energized during 15
minutes after the ignition has been set to the
OFF position. Prior to working on one of
these electrical components, set the battery
master switch in the main power
compartment to the OFF position. If the
vehicle will not be operated for a long period
(more than 2 weeks), it is recommended, in
order to prevent the batteries from
discharging, to trip the main circuit breakers
located in the main power compartment to
stop the small current drawn by the radio
preset station memory, the MCM memory
and the instrument cluster clock. Note that
the radio station presets will be erased,
same thing for the diagnostic codes history
and the instrument cluster clock will have to
be reset.
CAUTION
PRECAUTIONS ARE TO BE OBSERVED
BEFORE WELDING TO MINIMIZE THE
RISK OF MAJOR AND COSTLY
DAMAGES CAUSED TO THE VEHICLE
ELECTRONIC COMPONENTS!
1. Set the battery master switch to “OFF”
position.
2. Trip circuit breaker CB2 and CB6.
3. Disconnect electronic ground terminal
from the ground junction block located
in the battery compartment.
4. Make sure to clamp the welding ground
return as close as possible to the
welding point and make a good electric
contact to the chassis.
Detailed instructions are provided in
section 00-GENERAL of your vehicle
maintenance manual.
Summary of Contents for X3-45 2017
