Starting and Stopping Procedures
PA1627 X3-45 Operator’s Manual
6-3
Set the battery master switch and ignition to the
ON
position;
06621_3
BATTERY MASTER SWITCH
DANGER
Do not wear loose clothing when working near
engine. Stand clear of rotating components.
Press the rear start button to start engine from
engine compartment
When servicing the engine, push the engine
STOP button to prevent the engine from being
started from the dashboard ignition key or the
rear start button.
Once servicing is done, pull or twist the button to
allow normal engine start.
CAUTION
Refer to cautions in “Starting From The
Driver’s Seat” in this chapter
REAR START PANEL
DANGER
Rotating shafts can be dangerous. You can
snag cloths, skin, hair, hands, etc. This can
cause a serious injury or death. Do not work
on a shaft (with or without a guard) when the
engine is running.
STOPPING THE ENGINE
Press the red engine STOP button while the
engine is running to stop the engine.
CAUTION
Do not stop engine by any other method.
COLD WEATHER STARTING
When starting a cold engine, the intake air
should be warmed up by using the intake air
preheater. Turn the ignition switch to the ON
position. The preheater will not engage at
coolant temperature above 54°F (12°C). If the
coolant temperature is below 54°F (12°C), the
preheater will engage and will light the preheater
telltale between 0 and 50 seconds, depending
on the engine coolant temperature. Wait before
the preheater telltale has turned off before
starting the engine.
If necessary, once the engine has started, the
preheater will reengage (post heating) for the
same length of time as the preheat time.
WARNING
Do not
use ether or other combustible starting
aid fluid on any engine equipped with an
intake air preheater. If the engine is equipped
with a preheater, introduction of ether or
similar starting aids could cause a fire or
explosion resulting in severe property
damage, serious personal injury or death.
Engines not equipped with an intake air
preheater may, depending on coolant
temperature, take longer to start. If this should
happen, DO NOT release the ignition key until
the engine has started (while still observing the
15 second maximum cranking time).
JUMP STARTING
In order to avoid damage to solid-state electrical
components, it is important that jumper (booster)
Summary of Contents for X3-45 2017
