SECTION 09: PROPELLER SHAFT
2
DOB 2490-2789 | X3-45 Commuter PA1605 Maintenance Manual (Final Version – Rev.2 April 2016)
ILLUSTRATIONS
FIGURE 1: PROPELLER SHAFT ASSEMBLY DOB 2490-2789 ............................................................................................................ 3
FIGURE 2: COLD FORMED BEARING RETAINER AND BOLTS AS USED ON PREVOST X3-45 COMMUTER ............................... 4
FIGURE 3: BEARING LUBRICATION ZIRK ........................................................................................................................................... 6
FIGURE 4: BEARING LUBRICATION .................................................................................................................................................... 6
FIGURE 5: C-CLAMP ............................................................................................................................................................................. 6
FIGURE 6: CHECK FOR LOOSENESS ................................................................................................................................................. 7
FIGURE 7: PHASING MARKS ............................................................................................................................................................... 7
FIGURE 8: PHASING MARKS ............................................................................................................................................................... 7
FIGURE 9: PHASING MARKS ............................................................................................................................................................... 7
FIGURE 10: PHASING MARKS ............................................................................................................................................................. 8
FIGURE 11: PROPELLER SHAFT PROPER ORIENTATION ............................................................................................................... 8
FIGURE 12: COLD FORMED BEARING RETAINERS .......................................................................................................................... 8
FIGURE 13: UNSEATING BEARING CUP ASSEMBLIES ..................................................................................................................... 8
FIGURE 14: RAISED METAL OR FRETTING ON OPEN YOKE CROSS HOLES ................................................................................ 8
FIGURE 15: SPRING TAB BOLTS REMOVAL ...................................................................................................................................... 9
FIGURE 16: CORRECT POSITIONING ................................................................................................................................................. 9
FIGURE 17: INCORRECT POSITIONING ............................................................................................................................................. 9
FIGURE 18 ............................................................................................................................................................................................. 9
FIGURE 19 ............................................................................................................................................................................................. 9
FIGURE 20: RAISED METAL OR FRETTING ...................................................................................................................................... 10
FIGURE 21: BOOT CLAMP .................................................................................................................................................................. 10
FIGURE 22: CLEAN GREASE FROM SPLINE SLEEVE ..................................................................................................................... 10
FIGURE 23: APPLY GREASE .............................................................................................................................................................. 10
FIGURE 24: POSITION THE END OF THE BOOT AT THE 2.25 INCHES .......................................................................................... 11
FIGURE 25: ALIGN THE PHASING MARKS BETWEEN THE YOKE AND PROPELLER SHAFT ..................................................... 11
FIGURE 26: YOKE TAB (EAR) ............................................................................................................................................................. 11
FIGURE 27: GREASING BEARING CUP ............................................................................................................................................. 12
FIGURE 28: POSITION THE JOURNAL CROSS INTO THE YOKE CROSS HOLES......................................................................... 12
FIGURE 29 ........................................................................................................................................................................................... 12
FIGURE 30 ........................................................................................................................................................................................... 13
FIGURE 31 ........................................................................................................................................................................................... 13
