5-42 Other Features
DOB 1300-1556
PA-1639 Operator's Manual 2020 X3-45 Commuter
l
Wheelchair occupant should face outward when entering or exiting vehicle.
l
Do not back onto platform when exiting vehicle. FACE OUTWARD, and verify that platform is at the same
height as floor. Check that front rollstop is up and locked.
l
The front rollstop is intended to prevent slow, unintentional, rolling off of platform.
l
The front rollstop is not intended to stop a quick moving wheelchair. A quick moving wheelchair could tip if
the small front wheels collide with the rollstop. Also, the large rear wheels of a quick moving wheelchair
could roll over the rollstop. Possible injury to the occupant might occur in either case.
l
Verify that wheelchair fits safely on platform; it must not extend beyond edges or interfere with operation
of rollstop.
l
Do not operate with a load in excess of 660 lbs (300 kg) for Mirage Model F9TF and 800 pounds (363
kilograms) for Mirage Model F9TH.
l
Keep arms, legs, and clothing away from moving lift parts.
l
The lift is intended for one wheelchair and its occupant, or one standee. Do not overload lift.
l
Keep others clear while operating lift.
l
Do not allow an untrained person to operate lift.
l
Do not allow anyone to stand on bridgeplate. A bent bridgeplate can interfere with the platform as it raises
and lowers.
l
Lock wheelchair brakes before raising or lowering platform (power chair users should turn off power and
set brake).
l
Use great care in wet conditions; the wheelchair brakes are less effective if its tires or the platform are
wet.
l
Do not leave deployed platform unattended. Return to stowed position after use.
Hand-Held Control Pendant And Motion
The lift is operated with a hand-held, hard-wired remote-control pendant. Turn on the
POWER ENABLE switch and then control each lift motion by pressing an appropriate
button.
The POWER ENABLE switch provides power to the pendant and thereby enables the lift.
When turned on, the power switch and each button illuminate.
Pressing the DEPLOY/OUT button extends the platform from the lift storage
compartment, and pressing the STOW button retracts the platform back into the storage
compartment. Pressing the DOWN button lowers the platform towards the ground, and
pressing the UP button raises the platform towards the vehicle floor.
A button must be held depressed until the motion is completed. Movement of the platform
can be halted at any time by releasing the button.
FIGURE 7: HAND-
HELD CONTROL
PENDANT
MOTION
DESCRIPTION
DEPLOY
/ OUT
Platform extends out of vehicle, or deploys.
DOWN
Platform lowers from present height towards ground; front rollstop
lowers when platform contacts ground
Summary of Contents for X3 Commuter
