F046 + F047 — 09 /16— A4
For more wonderful cages, toys, and accessories for dogs, cats, birds, chickens, rabbits, ferrets and small animals, visit www.prevuepet.com
2
b
To continue assembly of the
CAGE UNIT
, you will need
these pieces:
3
Food/water cups:
Hook the
cups
onto the horizontal wire under
the snap-spring side doors.
Perches:
Install
perches
on a vertical wire, resting on a
horizontal wire for stability. Stagger perch place-
ment to allow birds to sit, fly, and move about.
Grille and Tray:
Rotate the windbell lock out of the way and
slide the
grille
into the top channel.
Slide the
tray
into the bottom channel.
4
To install the
COMPONENTS
,
you will need these pieces:
To attach the
CAGE UNIT to
the STAND UNIT
, you will
need the two completed units
with hardware:
× 4 sets
× 8
Align the extended wires along the back edge of the
roof panel
with holes on the back panel frame, and the
extended wires along the side panels with holes on the
underside of the roof frame.
Attach the roof with two hex screws at the back corners.
WITHOUT an assistant, lay the
cage unit
and the
stand unit
on
the floor.
Align the holes through the
stand
unit
with the holes through the
lower side panel on the
cage unit.
Attach together with the hex screw/
nut pairs. Push the screw through
from the cage exterior and tighten
the nut from the cage interior.
WITH an assistant, the
cage unit
and the
stand unit
can be assembled
together upright or laying flat.
Stand the cage upright.
Your Flight Cage is now fully assembled.
If you have an assistant, have them hold the unit upright while you
align all extended wires of the roof/side panels with the holes on
the backside frame of the
front panel.
Double-check the alignment of
extended wires for the entire cage.
Attach the front panel to the cage
with six hex screws.
