XTR-PX2-C0006-IN004
10-4
10.3 Jig and tool list
<Preparation before installation>
- Impact drill
- Drill guide, Kamizawa K-801
Installation
- Circuit tester (for measuring resistance values)
- Phillips head screwdriver
- Flat-blade screwdriver (Wago-made terminal block)
- Hexagon torque wrench (for 5, 6, and 10-mm cap screws)
- Heyco plier
- Collimator adjusting screws (M3-25 and M4-35 mm, x2 for each)
- Protection sheet for the base (PreXion)
- Drive jig for the PILLAR motor (PreXion)
- Geometry phantom (Small Balls phantom) (PreXion)
- Positioning guide rod for connecting the Rotation Arm (x3, PreXion)
- Cable ties (spare, 100, 190, and 300 cm)
- Trim (
for protection of the metal cover’s edge)
- Towels (for protection of the metal covers from being scratched)
- Paper tape (for protection of the metal covers from being scratched)
- Camera Position Adjustment Jig (PreXion)
- Step Ladder, (for viewing the Rotation Arm connection part and attaching the screws from the top)
10.4 Tightening torque list
Target
Screw
Tightening torque
Ref.
For fixing the base of the PILLAR
Hexagon socket head cap screw (M10 x 4)
25 N
・
m (Anchor)
Wall fixing bracket and wall
(except when fixation to wall does not
use anchors)
Hexagon socket head cap screw (M10 x 4)
25 N
・
m (Anchor)
Main body and wall fixing bracket
Hexagon socket head cap screw (M6 x 2)
7.1 N
・
m
PILLAR and Stationary Arm
Hexagon socket head cap screw (M6 x 6)
5.1 N
・
m
Stationary Arm and Rotation Arm
Hexagon socket head cap screw (M5 x 6)
3.0 N
・
m
Stationary Arm and Chin Rest Arm
Hexagon socket head cap screw (M5 x 6)
3.0 N
・
m
