XTR-PX2-C0006-IN004 Stand
6
3-5. Attach NUT with NUT HOLDER on the BASIC FRAME
（
16 locations
）
3-6. Build BASIC FRAME on the STAND BASE
Attach HEAVY BRACKET at bottom with HEAVY BRACKET tentatively( 16 screws ).
Remember the BASIC FRAME has top/bottom direction.
Attach the HOLDER at the NUT and insert them
in the ditch in the surface. And slide them to the
proper location.
Place NUT in the upper side ( surface side ) on
the HOLDER.
Caution:
BASIC FRAME has top and bottom direction.
On the top surface, screw holes are tapped for the STAND
PLATE TOP.
screw holes on the top
16 locations for NUT and NUT HOLDER
for STAND BRACKET MIDDLE
( 2 x 2 = 4 )
for STAND BRACKET BOTTOM
( 2 x 4 = 8 )
for WALL PLATE
( 4 )
BASIC FRAME
STAND BASE
HEAVY BRACKET (4)
960 mm
882 mm
60 mm
BASIC FRAME edge
Screw Bag G
Screw Bag D
Screw Bag B
Screw Bag D
Screw Bag B
Screw Bag C
