XTR-PX2-C0006-IN004 Stand
7
3-7.Attach STAND PLATE TOP on the top of BASIC FRAME with 4 screws tightly
3-8.Attach STAND BRACKET parts on the BASIC FRAME tentatively
- Attach STAND BRACKET TOP onto the BASIC FRAME by two screws
- Attach STAND BRACKET MIDDLE onto the BASIC FRAME by two screws x 2
- Attach STAND BRACKET BOTTOM onto the BASIC FRAME by four screws
3-9. Confirm the wall fixing point and screw the BOARD ANCHOR into the wall plate
（
in total 10 locations for top, middle, and bottom
）
3-10. Affix the wall BRACKET by board anchor screws with washers ( 10 locations )
3-11. Place Excelsior PILLAR ASSY on the STAND BASE
Screw the bottom tentatively
3-12. Attach WALL PLATE on the BASIC FRAME
board anchor
board anchor ( same as above )
not tightly yet
tightly for 4 locations
( height 882mm )
with washers
When possible,
confirm the horizontal levelness
before placing the Pillar Assy.
Screw Bag D
Screw Bag B
