B
AD
B
OY
™ S
POT
L
UMINAIRE
U
SER
M
ANUAL
2 2
02.9812.0001A
Menu System
Using the Menu Touchscreen
The menu system is a set of software screens used to configure, address, report status, and test the
luminaire. These functions are controlled at the Menu Touchscreen as shown in
Figure 3-1
.
Figure 3-1: Menu Touchscreen
Color Codes
The menu screens are color coded as follows:
•
Blue
- function control screens. These are configurable functions which will open a sub-menu
when touched.
•
Green
- informational screens. These display status info and will not open further menus when
touched.
•
Red
- important control screens. These are configurable functions which will open a sub-menu
when touched. Activating these functions will affect important luminaire settings.
Navigation
To navigate the menus, press the blue or red areas of the touchscreen.
Screen Saver Mode
The menu will automatically return to the Home screen, from a sub-menu, if inactive for 45 seconds.
The display will go into screen saver mode (backlight off) if inactive for five minutes.
The menu will automatically jump to the Status screen and wake up the display when a mechanism
status changes (error, calibration, etc.).
On-Board Battery
The luminaire contains an on-board battery so that it can be addressed and configured without being
connected to main power.
Bypass Calibration
If the menu screen is touched (in the center) and held during startup, the luminaire will present a menu
that provides the option to bypass calibration. This feature allows the luminaire to skip the calibration
sequence so that it can be powered up in the case for configuration purposes. (Refer to
"Bypassing
Calibration" on page 18
.)
CONFIG
addr
043
univ
A
1400w
ETHERNET
COMM
IN
DMX
THRU
15A Max
AC IN
200 -240 VAC
50 / 60 Hz
LAMP
hrs
125
temp
34C
INFO
01:34
TEST
COMM
DMX
STATUS
OK
Menu Touchscreen
-
Used to configure
luminaire address
and other options.
Also, provides status
information and
testing.
