22
V I I . D I S A S S E M B LY A N D A S S E M B LY
DISASSEMBLY
You can disassemble the scooter into several
pieces: the seat, the front section, the rear section,
the battery shroud (if equipped), the basket, and the
batteries.
See figure 21.
No tools are required to
disassemble or assemble your scooter, but keep in
mind that the disassembled sections of the scooter
take up more floor space than the assembled unit.
Always disassemble or assemble your scooter on
a level, dry surface with sufficient room for you to
work and move around your scooter–about 1.5
meters (5 feet) in all directions. Remember that
some scooter components are heavy and you may
need assistance when lifting them.
WARNING! Do not lift beyond your
physical capability. Ask for assistance
when necessary while disassembling or
assembling your scooter.
Figure 21. Scooter Components
FRONT SECTION
SEAT
REAR SECTION
REAR SHROUD
BATTERIES
BASKET
Figure 23.Tiller Lock Knob (Unlocked)
1. Place the scooter in drive mode by engaging the freewheel lever.
2. Lock the tiller in the straight ahead position by pushing the tiller lock knob in and turning it clockwise
90°.
See figure 22.
The front wheel must face forward in order to lock the tiller.
3. Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance when
removing the seat, disengage the seat rotation lever and swivel the seat back and forth while lifting
up on the seat.
4. Gently pull the rear shroud up and off of the rear section of the scooter.
5. Unplug the front-to-rear and rear lighting harnesses by squeezing the sides and pulling straight up.
See figure 23.
Figure 22. Tiller Lock Knob (Locked)
LOCKED POSITION
UNLOCKED POSITION
