23
Figure 24. Harness Connections
REAR LIGHTING HARNESS
BATTERY HARNESS
V I I . D I S A S S E M B LY A N D A S S E M B LY
6. Unplug both battery harnesses. Pull each
harness straight up.
See figure 24.
7. Unfasten the battery tie-down strap and remove
the batteries from the battery wells.
8. Squeeze the tiller adjustment lever and lower
the tiller to it’s lowest point.
WARNING! Failure to unplug both battery
harnesses, the front-to-rear harness, and
rear lighting harness prior to separating
the front and rear sections could result in
permanent damage to the scooter.
Frame Separation
1. Lift up on the frame release lever.
See figure 25.
2. Lift the front section up until the frame hooks of
the front section separate from the rear section.
See figure 25.
NOTE: Stabilise the rear section with your free
hand by holding onto the upper frame tube. See
figure 26.
3. Slowly separate the two sections.
See figure 26.
ASSEMBLY
1. Position the front and rear sections of your
scooter as shown in
figure 26.
2. Use the frame release lever to lift the front
section as you align the frame hooks of the front
section with the lower frame tube of the rear
section.
See figure 26.
3. Once the frame hooks are over the lower frame
tube, lower the front section completely. This will
engage the frame lock.
See figure 25.
4. Raise the tiller.
5. Reinstall both batteries and secure with tie-down
straps— making sure the strap is positioned
over the frame release lever to ensure proper
securement.
6. Connect the front-to-rear harness, rear lighting
harness, and both battery harnesses.
See
figure 24.
7. Reinstall the rear shroud.
8. Reinstall the seat and rotate it until it locks into
place.
9. Unlock the front wheel by turning the tiller lock
knob 90° anticlockwise.
See figure 23.
WARNING! After assembly, make
absolutely certain the tiller lock knob is in
the unlocked position before riding your
scooter.
Figure 25. Frame Release
Figure 26. Frame Separation
FRAME RELEASE LEVER
LOWER FRAME TUBE
FRAME HOOKS
FRONT-TO-REAR HARNESS
FRAME LOCK
FRAME HOOK
UPPER FRAME TUBE
