27
I X . C A R E A N D M A I N T E N A N C E
ABS PLASTIC SHROUDS
The shrouds of the scooter are formed from durable ABS plastic and are coated with an advanced
formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power lead, for wear or damage.
Have your authorised Pride Provider repair or replace any damaged connector, connection, or
insulation that you find before using your scooter again.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
The battery terminals should face the rear of the scooter.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected
periodically for wear by your authorised Pride Provider.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
You do not need to lubricate these items, as they are all prelubricated and sealed.
Diluted Bleach Solution (10% dilution or
less); Note: Bleach with pH factor between
7 and 9 is suitable; a product with a pH of
10.5 or higher may damage the vinyl surface
integrity over an extended period of time.
Disinfecting Wipes
Clorox, Green Works, PDI Sani-Cloth HB
Wipes, Lysol, Oxivir, Virox, and CaviWipes.
{
For Tire cleaning, clean with off the shelf tire/wheel
cleaners
Electronics
(Joystick controller, enhanced displays, touch
screens, remote controls, keyboards, cell phones and tablets,
as applicable)
●
For electronics, remove visible contamination if present.
{
Turn off device and disconnect batteries.
{
Never spray any liquids directly into the product(s).
{
Moisten a microfiber cloth with a mixture of 70% isopropyl
alcohol/30% water solution. The cloth should be damp,
but not dripping or excessively wet. Dry surfaces
thoroughly to avoid pooling of liquids and prior to boxing.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or premature
deterioration of upholstery and/or power chair finishes.
WARNING! Never hose off your power chair or place it in direct contact with water. Your power chair has
a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
