30
Ultimate 3-4/Rev A/July03
V I I . C O M F O R T A D J U S T M E N T S
Figure 11. Seatback Adjustment
SEATBACK ADJUSTMENT
LEVER
ARMREST ANGLE ADJUSTMENT
The armrest angle of your scooter can be adjusted up-
ward or downward by turning the adjustment dial. See
figure 11A.
NOTE: The armrests also pivot
upward to make getting on and off
of your scooter easier.
SEAT HEIGHT ADJUSTMENT
You can change the seat height to one of three positions
in 2.5 cm increments. See figure 12.
Changing the seat height:
1. Turn the scooter off and place the manual freewheel
lever in drive mode.
2. Lift the seat up and out of the seat post.
3. Loosen and remove the seat height adjustment bolt
,bolt-nut, and washers.
4. Slide the upper seat post up or down in the lower
seat post.
5. Align the adjustment holes of the upper seat post and
the lower seat post.
6. Reinstall the seat height adjustment bolt, bolt-nut,
and washers, then tighten.
7. Reinstall the shroud.
8. Reinstall and lock the seat into place.
Figure 12. Seat Height Adjustment
LOWER SEAT POST
UPPER SEAT POST
BOLT-NUT
WASHER
SEAT HEIGHT
ADJUSTMENT BOLT
WASHER
Figure 11A. Armrest Angle Adjustment
ADJUSTMENT DIAL
SEATBACK ADJUSTMENT
To adjust your scooter's reclining seat, perform these steps.
See figure 11.
1. With your back pressed up against the seatback, lift
up on the seatback adjustment lever and lean forward
or rearward to adjust the seatback angle.
2. Release the seatback adjustment lever once the seat
is in a comfortable riding position.
WARNING! Do not operate your
scooter with the seatback in a
reclined position.
WARNING! Always keep your back
pressed firmly against the seatback
while adjusting the angle.
