34
Ultimate 3-4/Rev A/July03
V I I I . D I S A S S E M B LY A N D A S S E M B LY
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 19.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section.
3. Holding the seat post, slowly pivot the rear section for-
ward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figures 19 and 20.
4. Raise the tiller.
5. Secure the toggle latch. See figure 15.
n
Lower the toggle latch buckle.
n
Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness and both 2-pin,
black and white battery harnesses.
7. Replace the shroud.
8. Replace the seat, and lock it into place.
WARNING! Position the front-to-rear
harness cable so it wont become
pinched between the frame halves
when pivoting the rear section forward.
See figure 20.
Figure 19. Frame Sections
Figure 20. Frame Lockup
FRONT-TO-REAR HARNESS CABLE
PEG
CURVED LOCKING BRACKETS
