INFINFB2039/Rev B/07-31-08
www.pridemobility.com
2
B
ASIC
T
ROUBLESHOOTING
I
NSTRUCTIONS
: E
LITE
T
RAVELLER
S
ERIES
What if the battery condition meter dips way down and the motor surges or hesitates when I press the throttle
control lever?
Fully charge the batteries. Pride recommends you charge the batteries for 8-14 hours.
DIAGNOSTIC BEEP CODES
BEEP CODE
CONDITION
SOLUTION
2
Battery voltage is too low to operate
Charge the batteries fully until charger and
the Travel Scooter.
any meters indicate completion.
3
Battery voltage is too high to operate
Contact your authorized Pride Provider for
the Travel Scooter.
assistance.
5
Solenoid brake trip. The manual freewheel
Remove the key, then push the manual
lever may be in the freewheel position.
freewheel lever to the drive position and
restart the Travel Scooter.
6
Throttle trip. The throttle control lever
Release the throttle control lever completely,
may have been depressed while inserting
then reinsert the key.
the key.
7
Throttle trip. Throttle potentiometer
Contact your authorized Pride Provider for
fault or speed potentiometer fault.
assistance.
8
The motor is disconnected.
Contact your authorized Pride Provider for
assistance.
9
Possible controller trip. You may be
Shut down your Travel Scooter for a
attempting to install the battery pack while
minimum of several minutes to allow the
the key is inserted or the motor controller
controller to cool. Or, try reinserting the key
may be in overheat protective mode.
into the key switch.
