16
To install the positioning belt:
1. Remove the rearmost screw that holds the under-seat storage (
see fi gure 4
)hinge to the seat base
on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through the positioning belt and into the seat base for
each side of the travel chair seat.
3. Tighten both screws.
To adjust the positioning belt:
1. Once seated, insert the metal tab on one side of the belt into the plastic housing on the opposite side
until you hear a click.
See fi gure 13.
2. Pull the excess strap attached to the metal tab until it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the travel chair and
is adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose parts or damage, including tears,
worn spots, bent hardware, damaged latch mechanisms, dirt or debris, before each use
of the travel chair. If you discover a problem, contact your authorized Pride Provider.
Positioning Belt
Your Go-Chair may be equipped with a positioning
belt that can be adjusted for operator comfort.
See fi gure 13.
The positioning belt is designed to
support the operator so that he/she does not slide
down or forward in the seat. The positioning belt is
not designed for use as a restraining device.
WARNING! The positioning belt is
not designed for use as a seat belt
in a motor vehicle. Nor is your travel
chair suitable for use as a seat in
any vehicle. Anyone traveling in a
vehicle should be properly belted
into seats approved by the vehicle
manufacturer.
WARNING! The positioning belt
should be secured at all times. Never
allow the positioning belt to hang or
drag on the fl oor as it may become
entangled.
1
Figure 13. Positioning Belt Adjustment
Identifi cation Key
1. Positioning Belt
