22
ES2
To check a fuse:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown.
See
figure 17
.
3. Insert a new fuse of the proper rating.
WARNING! The replacement fuse
must exactly match the rating of
the old fuse. Failure to use properly
rated and approved fuses may
cause damage to the electrical
system.
What if the Travel Scooter’s batteries won’t charge?
Check the fuse located under the shroud. Replace if necessary.
During the charging process, if the charger LEDs never indicate a full charge, check the fuse. Replace
if necessary, or have your authorized Provider or qualified technician check and/or replace the fuse.
Ensure both ends of the charger power cord are connectly properly.
If the fuse continually blows, contact your authorized Provider for service.
What if the main circuit breaker repeatedly trips?
If the main circuit breaker trips repeatedly, see your authorized Provider for service.
Charge the Travel Scooter’s batteries more frequently. See III. “Batteries and Charging.”
If the problem continues, have both of your Travel Scooter’s batteries load tested by your authorized
Provider.
You may also perform the load test yourself. Battery load testers are available at most automotive
parts stores.
Follow the directions supplied with the load tester.
See III. “Batteries and Charging” or “Product Specifications Sheet” for information about your Travel
Scooter’s battery type.
What if the battery condition meter dips way down and the motor surges or hesitates when I press
the throttle control lever?
Fully charge your Travel Scooter’s batteries. See III. “Batteries and Charging.”
Have your authorized Provider load test each battery.
Or, see the previous troubleshooting question for load testing the batteries yourself.
If you experience any problems with your Travel Scooter that you are not able to solve, immediately
contact your authorized Provider for information, maintenance, and service.
V I I . B A S I C T R O U B L E S H O O T I N G
Figure 17. Fuse Replacement
What if all the systems on my Travel Scooter seem to be “dead”?
Make certain that the power switch is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See II. “Your Travel Scooter.”
Make certain that the batteries are seated properly.
Be sure the power down timer feature has not been activated. See IV. “Operation.”
Check the battery charger fuse located under the shroud.
See figure 10.
Working Fuse
Blown Fuse (Repl
a
ce)
