34
www.pridemobility.com
Jazzy 1100/RevJ/Feb03
V I I I . O P E R A T I O N
n
Ripple up and down of lights: The joystick was not in the center position when the controller was
turned on. If you get ripple up and down of lights, turn off the controller, allow the joystick to return
to the neutral position, then turn on the controller.
NOTE: If you still get ripple up and down of lights, contact your authorized Pride Provider.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash,
reminding you the batteries need to be charged immediately!
Speed Settings
The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest
speed setting is 5. The settings are indicated by the number of lights that are lit.
NOTE: The speed settings are preset at the factory. If your authorized Pride provider changes the order
of these settings, please make note of these changes. Contact your authorized Pride provider for more
information.
To select a speed setting:
1. Press the on/off key to power on the remote.
2. Press the mode key once.
3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase
the speed setting.
4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the
speed setting.
5. Once you select the desired speed setting, press the mode key once to keep the setting or push the
joystick in the forward or reverse direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests,
you can operate them through the remote keypad. Contact your authorized Pride provider for information
on how to operate these accessories.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on
the front of the controller. See figure 34. The socket may also be used for reprogramming the controller by
using a Penny & Giles Programmer, should this be necessary. If you use an off-board charger, the charger
current should not exceed 12 amps. Contact your authorized Pride provider for more information.
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board
charger/programming socket. See your authorized Pride provider for more information.
