40
www.pridemobility.com
Jazzy 1100/RevJ/Feb03
NOTE: The socket may also be used for reprogramming the Europa. Contact your authorized Pride
provider for more information.
Sleep Mode (If Enabled)
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically
shut off the main power if the joystick is not moved in any direction for a period of time. This time factor
is programmed into the controller. To restore power and continue, push and key on the keypad.
Trouble Codes
The system status light is displayed within the on/off key. This light is lit if the system is turned on. It also
flashes in groups called flash codes, to indicate system faults. The table below identifies the individual
fault codes. If your keypad displays one of these codes, contact your authorized Pride provider.
NOTE: You must turn the controller off and then on again to reset the controller, even if the source of the
fault is removed/corrected.
In the event of a fault, the system status light displays diagnostic indications. Faults are encoded as follows:
one (for a low battery voltage fault) to twelve (module mismatch) and are displayed by the light flashing
the number of times prescribed by the fault code. The flash sequence (one to twelve) is followed by a long
off period (2 seconds). If more than one fault exists, then the fault having the highest priority is indicated.
The controller must be turned off and then on again even if the source of the fault is removed. If you cannot
resolve the problem, contact your authorized Pride provider.
V I I I . O P E R A T I O N