UK Jazzy 1113/RevF/Apr03
www.pridemobility.com
39
V I I . O P E R A T I O N
Sleep Mode (If Enabled)
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main power
if the joystick is not moved in any direction for a period of time. This time factor is programmed into the controller. To restore
power and continue, push the on/off key on the keypad.
Trouble Codes
The system status light is displayed within the on/off key. This light is lit if the system is turned on. It also flashes in groups called
flash codes, to indicate system faults. The table below identifies the individual fault codes. If your keypad displays one of these
codes, contact your authorised Pride Dealer.
FLASH CODE
SEQUENCE
DIAGNOSIS
SOLUTION
•—•—•—
DX module fault
See your authorised Pride dealer.
••—••—••—
DX accessory fault
See your authorised Pride Dealer.
•••—•••—
Left motor (or connection) fault
Check left motor wiring.
••••—••••—
Right motor (or connection) fault
Check right motor wiring.
•••••—•••••—
Left park brake fault
Check motor/brake wiring.
••••••—••••••—
Right park brake fault
Check motor/brake wiring.
•••••••—•••••••—
Low battery fault
Check that the battery wiring is secure.
•••••••—•••••••—
Over voltage fault
Check that the battery wiring is secure.
•••••••—•••••••—
CANL fault
See your authorised Pride Dealer.
•••••••—•••••••—
CANA fault
See your authorised Pride Dealer.
•••••••—•••••••—
Stall timeout
Turn unit on, then off.
•••••••—•••••••—
Module mismatch
See your authorised Pride Dealer.
NOTE: You must turn the controller off and then on again to reset the controller, even if the source of the fault is
removed/corrected.
In the event of a fault, the system status light displays diagnostic indications. Faults are encoded as follows: one (for a low battery
voltage fault) to twelve (module mismatch) and are displayed by the light flashing the number of times prescribed by the fault
code. The flash sequence (one to twelve) is followed by a long off period (2 seconds). If more than one fault exists, then the fault
having the highest priority is indicated. The controller must be turned off and then on again even if the source of the fault is
removed. If you cannot resolve the problem, contact your authorised Pride Dealer.
