18
www.pridemobility.com
Jazzy 1115 Rev H/Feb03
I V . T H E J A Z Z Y 1 1 1 5
POWER BASE COMPONENTS
The power base consists of the following components:
n
Charging Ammeter:
The ammeter displays the chargers current output in amps. See figure 2. For
more information, see IX Batteries and Charging.
n
Charger Fuse:
This protects the Jazzy from high charging currents. It takes a 7.5 amp fuse. There is an
extra 7.5 amp fuse attached to the rear battery box. See figure 2.
n
Main circuit breaker:
The main circuit breaker is a safety feature built into your Jazzy 1115. When the
batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips
to prevent damage to the motors and the electronics. If the circuit trips, allow the Jazzy to rest for
approximately one minute. Then, push down the circuit breaker button, turn on the joystick controller,
and continue normal operation. If the main circuit breaker continues to trip repeatedly, contact your
authorized Jazzy 1115 provider. See figure 3.
n
Controller Harness Connectors:
These are where the joystick cables connect to the power base. See
figure 2.
n
Motor Connectors:
These are where the joystick controller and batteries connect to the motor/brake
assemblies. See figure 2.
n
Battery Charger:
The battery charger is attached to the rear battery box. See IX. Batteries and Charging
for more information. See figure 2.
n
Battery Boxes:
There are two battery boxesfront and rear. The front battery box houses the main
circuit breaker. The rear battery box houses the ammeter, the charger fuse, the controller connectors,
and the motor connectors. See figures 2 and 3.
n
Drive Motor Assemblies:
There are two drive motor assemblies. Each assembly consists of
a motor, an electronic brake, a gearbox, and a freewheel lever. See figures 2 and 3.
n
Front-to-Rear Battery Connector:
This is where the front and rear batteries connect to each other.
See figure 3.
