Jazzy 1115 Rev H/Feb03
www.pridemobility.com
21
V . A S S E M B L Y
Figure 7. The locating pins
Figure 8. The front-to-rear battery cable
connector
Figure 9. Motor harness connector
3. Fit the notch on either side of the rear of the battery
well frame onto the locating pin on the right frame
assembly and onto the locating pin on the left frame
assembly.
4. Make certain that the locking mechanisms snap
securely into place.
To install the battery cases:
1. Place the front battery case (with the battery inside)
into the front end of the battery well frame. Position
the battery case so that the circuit breaker reset
button is facing the front of the chair.
2. Place the rear battery case (with the battery inside)
into the back end of the battery well frame. The
charger fits between the rear angled supports of
the battery well frame and faces toward the back
of the chair.
3. Make certain that none of the wiring harnesses or
cables are pinched between the battery or the motor
controller box and the frame.
4. Connect the 2-conductor rear-to-front battery
cable connector from the rear battery case to the
socket on the top of the front battery case. Keep
the positive (+) and the negative (-) indicators on
the connector facing upward as you slide the
connector into the matching socket. Push the
connector firmly and fully into the socket. See
figure 8.
5. Plug the left, 4-conductor power cable connector
into the matching socket on the left frame assembly;
plug the right, 4-conductor power cable connector
into the matching socket on the right frame
assembly. See figure 9. Keep the red and black
conductor terminals facing up as you make the
connections. Push each connector into its matching
socket until you hear the click of the latching
mechanisms.
To install the seat:
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so, resulting in personal injury or
damage to the chair.
