29
JAZZY 1121/REV C/SEPTEMBER 2002
WWW.PRIDEMOBILITY.COM
V I I . O P E R A T I O N
REMOTE PLUS CONTROLLER
The Remote Plus is a modular electronic control system. The electronics necessary to operate the power chair are contained in
several modules located on different parts of your power chair.
The Remote Plus system consists of the following components:
n
master remote
n
communications cable(s)
n
power module
n
motor wiring harnesses
n
battery wiring harnesses
n
actuator lighting module (for optional equipment)
The master remote is located typically on the end of an armrest. The other components are located inside the power base.
Remote Plus Master Remote
The Remote Plus master remote consists of the following (see figure 18):
1. joystick
2. keypad
3. controller communications cable
4. off-board charger socket
Joystick
The joystick controls the direction and speed of your power
chair. When you move the joystick from the neutral (center)
position, the electromagnetic brakes release and allow your
power chair to move. The further you push the joystick from its
neutral position, the faster your power chair moves. When you
release the joystick and allow it to return to the neutral position,
you engage the electromagnetic brakes. This causes your power
chair to decelerate and come to a complete stop.
WARNING! If your power chair begins to move in an unexpected manner, immediately release the joystick.
Unless the joystick is damaged, this action should stop your power chair.
Keypad
The keypad is located directly in front of the joystick. See figure 19. It contains keys that you will use to control your
power chair.
On/Off Key
The on/off key toggles the system power on and off.
WARNING! Unless faced with an emergency situation, do not use the on/off key to stop the chair. This will
Figure 18. Remote Plus Master Remote
1
2
3
4
