20
www.quantumrehab.com
Quantum Jazzy 1420 Series
I V . A S S E M B L Y / D I S A S S E M B L Y
To install the seat:
1. Set the trapeze bars to the desired height. To change
the trapeze bar height, see V. “Comfort Adjustments.”
2. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 10.
3. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
Controller Installation
Depending on the various configurations and options you
have chosen for your power chair, it may have been shipped
without the controller module installed in the armrest.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or power base frame.
1. Flip up either the right or left armrest.
2. On a contour seat, flip up the armrest and loosen the
setscrew. See figure 11.
NOTE: If your power chair is equipped with a Syn-
ergy Seat or TRU-Balance Power Positioning Sys-
tem, refer to the controller installation and adjust-
ment information provided in separate manuals.
3. Slide the controller into the armrest.
4. Tighten the setscrew(s) and lower the armrest.
5. Route the controller cable so that it cannot be pinched
in the seat hinge.
6. Remove the rear lid to expose the electronics tray.
7. Plug the controller connector into the electronics tray.
See figure 7.
8. Secure the controller cable to the armrest receiver with
one or more wire ties.
Figure 11. Controller Installation (Underside of Armrest)
SETSCREW
CONTROLLER BRACKET
