22
www.quantumrehab.com
Quantum Jazzy 1420 Series
V . C O M F O R T A D J U S T M E N T S
11. Reinstall the ball detent pin into each seat tower.
12. Reinstall the shroud.
13. Reinstall the trapeze bars and secure with the quick-
release pins.
14. Reinstall the seat.
NOTE: Make sure the seat latch safety is flipped down
before using the power chair seat.
15. Plug the controller connector(s) into the electronics tray.
Seat Position Adjustment
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the seat position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the
electronics tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same number
of holes either forward or backwards. See figure 14.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller connector(s) into the electronics tray.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
High-Back with Headrest Adjustment (Optional)
If your power chair is equipped with the deluxe high-back
seat, you can adjust the headrest height.
To adjust the headrest height:
1. Push in the headrest release button.
2. Move the headrest up or down to the desired position.
SEAT MOUNTING HOLES
Figure 14. Seat Position Adjustment
