12
www.pridemobility.com
Jazzy EVO 614 Series
I V. A S S E M B L Y
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage
to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or through your authorized Pride Provider.
Figure 7. Seat and Controller Assembly
Seat Installation
It may be necessary to install the seat either prior
to initial operation or after transporting your power
chair.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do so.
To install the seat:
1. Slide the seat down onto the power base.
See
figure 7.
2. Install the controller into one of the armrests.
Tighten the setscrew with the supplied hex key.
3. Lift the armrest straight up, then route the
controller harness and secure with wire ties as
shown in
figure 7.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller harness
with wire ties.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the
inside of the armrest pad. Use correct
tie-down points for the controller
harness to prevent the harness from
getting caught in the wheels, pinched
in the seat frame, or damaged when
passing through doorways.
4. Plug the controller harness into the connector on
the power base.
See figure 3.
1. Wire Ties
2. Seat
3. Controller
4. Power Base
Identification Key
1
3
4
2
