Jazzy EVO 614 Series
www.pridemobility.com
15
V. C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the controller for
either left-hand or right-hand use.
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the
power base frame.
To extend the controller:
1.
Turn off the power to the controller.
2.
Flip up the armrest so it is perpendicular to the floor.
3. Loosen the setscrew on the controller bracket.
See figure 9.
4. Slide the controller into or out of the armrest to the desired position.
5. Tighten the setscrew to secure the controller.
To change the controller position:
1.
Turn off the power to the controller.
2. Unplug the controller connector(s) from the power base.
3. Cut the wire tie(s) securing the controller harness to the armrest.
4. Flip up the armrest and loosen the setscrew.
See figure 9.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrews in each armrest.
9. Secure the controller harness to the armrest with wire ties.
10. Plug the controller connector(s) into the power base.
1
3
2
Figure 10. Foot Platform Adjustment
Identification Key
1. Foot Platform
2. Hardware
3. Adjustment Screw
NOTE: If your power chair is equipped with a TRU-Balance
Seating System, refer to the controller adjustment information
contained in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several different
heights.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform bracket.
See figure
10
.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the hardware into the foot platform bracket and
tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the hardware from the foot platform bracket.
See figure
10
.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform bracket and
tighten.
